Search results for query: *

hi all, hope you are all well. having trouble with pto disengaging when tractor facing uphill. and tractor jumping through torque settings when under load. checked oil level and changed filters. any help greatly appreciated.

thanks again guys i started this job blind but i'm a bit wiser now

ok here 's how it worked out .... new pump ,no pressure so i took whole assembly off then i noticed no oil coming out off oil feed pipe, so to cut long story short when i was tapping out gasket for bell housing i did not tap out hole for oil feed . feeling stupid but relived tractor going...

yes tried that even filled the sump up level with fill bung, going for a new pump today.

oil filters rubber end first. backed it up a ramp still cant get oil flowing

i'll try backing it up a ramp tomorrow do i open the nut on the pipe when i do this

after engine rebuild i can't get any hydraulic pressure. i took the filter cover off and the shaft is turning. loosed the nut on the return pipe to try and bleed it. primed it from top nut with oil. any ideas?

i sent you a pic

thanks, but its not the bit i need i'll see if i can send a pic to you

try the 9245

it is

would you know the torque settings for big ends, main and head bolts are? going to put her together tomorrow

that would be great thanks

Hi all, anybody have diagram for front of gearbox for a 9540 i mixed up the washers etc on the shaft below the main drive shaft. many thanks

shaft out now thanks again!

Derry Lol

Thanks i'll get on with it now.

as in remove the bell housing from gearbox with shaft attached?

gearbox to clutch Thanks

Input shaft removal 9540 Hi all i hope you can help. Removed engine to fix another problem and found the main input shaft is worn. I removed side plate, figure 8 plate on front, cir clips on bearing but cant get shaft to pull. Any help greatly appreciated.