Search results for query: *

I have a 5211 with westendorf loader. It is currently plumbed through the rear auxilliaries. I understand I can get pressure from the outlet on the pump plate under the rear axle and put a return line into the plug hole in the bottom of the transmission. Is this the extent of the plumbing, or...

If I were to build one to pull behind a 3340, what would be an appropriate diff. ratio and tire combo. I could do the math but it seems easier to just ask. Of course I am referring to ground drive, not 540!

Thanks for the info. I finally got this problem fixed, I think. It wasn't much fun splitting the tractor, but waiting 6 weeks for parts was even less fun. I had to replace a shifting collar, the bronze washer and shim to tolerance; well over 300 bucks for pieces I could hold in the palm of my...

This question is related to my reverser troubles. How much play up and down, side to side is acceptable (normal) on the input shaft? I don't see any evident problems with bearing(s) or wear other than the bronze washer(s) discussed in the other thread. Play seems excessive though.

I have since split the tractor and removed the front cover from the gearbox. All parts appear to be present and in working condition from the manual. There is also the bronze spacer that I don't see on any of the parts diagrams. After the cover and hollow clutch shaft are removed, there it...

Thanks. I don't really want to get into this, but I guess it isn't optional. Kinda hard to use a tractor with no reverse. Wish I had waited and bought a better tractor. I don't know what the guy who had this one did to it, but I sure am tired of working on it. I know these things are built...

Until recently, I had only used a ground driven, side delivery rake and it worked fine. We then found a Vermeer twin rake, which is basically two side delivery rakes put together and driven hydraulically. This thing is sweet. However, it is too big to rake alfalfa that we bale into small...

I went to my local "dealer" and looked at their service manual. No synchro ring, but Renze is still probably correct. Just a ring and an insert held in place by a snap ring that all stops the gear from sliding on the shaft. I still was unable to decipher how to get it out. Appears that I...

That sounds about right. At times, if I get the light just right, I can see what looks like a piece of wire still on the shaft. I wonder what the odds are the ring would be intact and I could run a piece of wire behind it like dental floss and get it back home.

Thanks anyway. I wonder how much there is to this synchromesh ring. The reason I ask is that it appears I might be able to install a split shim between this ring and the reverser gear to take up the slop and solve my problem without splitting the tractor. I know that would be too good to be...

Hello all. I have a 3340 that will not stay in reverse. Detent checked OK. Removed the top from transmission to find that the problem involves the gear for reverse that is engaged by sliding collar. There appears too much play with this gear. It doesn't wobble on the shaft, but will slide...