Search results for query: *

A decent set of bale forks on the back might get me out of trouble for unloading the trailer I reckon.

Yes, will be doing a frame similar to that, depending on what I can find in the right size to copy I'd probably do level lift arms I think, round bales get stacked 4 high in my hay shed so that would make it a bit easier.

I'll have to check out the hydraulic side of it later on when I have had a look and understand the workings. I have a bit of experience with hydraulics but I'm not to familiar with tractor systems.

I'm a boilermaker by trade and the neighbor has a few front end loaders old and new so I''ll measure them up and work something out. The standard pump on a 7245 is 32l/m I read does that sound about right? is there an additional pump that is commonly used if more flow / pressure is needed or is...

Sounds good, I will more than likely make my own loader unless I can find something suitable that will fit so I can make that plenty strong enough and I can put bigger bore lift cylinders to give me a bit more grunt with lower pressure.

They load the bulk bags with a little forklift. Its not the main thing I want the tractor for so not worried about the full tonne, if I have to put a weight on the back that would be ok if it will do it, I just wanted to make sure these didn't have a weak axle or something that was going to...

Yes, would only be to get it off the trailer and in shed so not high and not far. Not fussed if it doesn't do it easily, just don't want to break anything expensive:) Specs on some of the early 90's models in similar size rate the loaders at over a tonne so surely not much would of changed in...

Fair enough, most bulk feed etc over here comes in 1 tonne bags and it seems most modern tractors of 75hp with a loader will lift over a tonne, the old zetors seem to be built tough but not sure if any were more prone to front axle issues that others. I wouldn't want to go much bigger so if the...

You think it would cope with unloading 800-1000kg feed bags off a trailer from time to time? It's is the axle I'm not sure about, I don't want to bust anything but it would be good if it could lift a tonne but I wont be doing that very often and wont be in a rush. I saw some specs online that...

Hi, I am in Australia and have been researching a lot of tractors since I need to buy one :) The old Zetors seem to tick a few boxes for me and I'm currently checking out a 7245. I am intending on fitting a loader to the tractor and am needing to know what sort of capacity this model can handle...