4341 jumping out of revers

[billyw61]

any help will be appritiated,4341 jumping out of revers.i have replaced the shifting fork,still same problem,comes out ever time in even if you hold the shifter in revers

 

[ixer0]

Hi

It sounds like the edges are worn off the reverse gear teeth. I have had this problem before and managed to extend the inevitable gearbox strip by altering the position of the selector spring slot on the selector rod. I welded the slot up and then ground a new slot slightly further along the rail so the gears meshed a bit deeper. You could also washer the selector lock spring up to make it stronger.

Mike

 

[billyw61]

thanks for the help ,ill give the washers a try 1st