4712 gearbox

[husdal]

Hi

one of the shift forks in my 4712 broke. on the way down it took out some gear tooths.

im about to tear this thing apart, but were can i get new sliding gears?

will this fit my 4712?
http://www.vrajtractor.com/index.php?productID=606

 

[Renze]

yes, exactly the same as 3011 and 3511, only the shafts are different (longer)

 

[husdal]

thank you, i'll start ordering then.. know of any good place online?
if i get the time, i will post some images of the work and the tracktor.

do i have split the tracktor between transmission case and the rear or front? or both?

its a 1975 4712 with cab and heating. only modification is a new ac alternator.
the old one, didn charge the battery when i used full power on lights and heater.

 

[Renze]

In a 3011 you can take out the top shaft when its only split at the clutch (and both input shafts are taken out)
On a 6711 you need to take the shaft out from the rear end because it has a machined chest against which the bearing rests, while in the 3011 the bearing is locked between TWO Seeger rings.