Hello Guest, you do not yet have the necessary rights to see the contents of our FAQ articles. Register in our forum, briefly introduce yourself and your Zetor in words and pictures and actively participate in discussions in the forum, then you will automatically receive access to the specialist articles in the FAQ.

Reply to thread

Message

Hi all,

I have a 6748 that ran great until recently (when I needed it for the snow).

It began by not starting, then after using the hand primer it would start, then die. I changed the filters and hand primer as each time there appeared to be air in the pump so I assumed blocked filters or an air leak in the primer.

Now it starts, run for a short time (about 1-2 minutes) then stops. The cold start button is in for start, but drops out when it dies off.

It is as if the throttle is pulled back slowly until it stops. (the throttle position hasn't changed on the governor body)

I'm assuming something internal - any clues??

[QUOTE="paulf, post: 14881, member: 1280"] Hi all, I have a 6748 that ran great until recently (when I needed it for the snow). It began by not starting, then after using the hand primer it would start, then die. I changed the filters and hand primer as each time there appeared to be air in the pump so I assumed blocked filters or an air leak in the primer. Now it starts, run for a short time (about 1-2 minutes) then stops. The cold start button is in for start, but drops out when it dies off. It is as if the throttle is pulled back slowly until it stops. (the throttle position hasn't changed on the governor body) I'm assuming something internal - any clues?? [/QUOTE]

Verification