Hi
Based on some excellent advice here I have purchased a new slave cylinder for my 5245. When I was getting ready to install it I discovered that the mounting bracket for the FEL was to close to the cylinder and I am not able to remove the pin that holds cylinder in place. I am short about 1.5 inches for space.
Any innovative ideas on how I might do this without taking the whole loader frame off. Is there such a thing as a pin with a hinge that might work?
Bob
Based on some excellent advice here I have purchased a new slave cylinder for my 5245. When I was getting ready to install it I discovered that the mounting bracket for the FEL was to close to the cylinder and I am not able to remove the pin that holds cylinder in place. I am short about 1.5 inches for space.
Any innovative ideas on how I might do this without taking the whole loader frame off. Is there such a thing as a pin with a hinge that might work?
Bob
