This question is related to my reverser troubles. How much play up and down, side to side is acceptable (normal) on the input shaft? I don't see any evident problems with bearing(s) or wear other than the bronze washer(s) discussed in the other thread. Play seems excessive though.
-
Hello Guest, you do not yet have the necessary rights to see the contents of our FAQ articles. Register in our forum, briefly introduce yourself and your Zetor in words and pictures and actively participate in discussions in the forum, then you will automatically receive access to the specialist articles in the FAQ.
clutch shaft play
- Thread starter dyates
- Start date
- Joined
- Jul 5, 2003
- Messages
- 4,064
- Location
- Laag Zuthem
- First name
- Renze
- Machinery:
- 1976 5718
1978 5718 35kmh: Work in progress
1967 3011
play on the clutch end (by tilting the shaft), where it normally sits in the pilot bearing inside the flywheel ? or axial play by racking it back and forth, or radial play by pulling it up and down ? Up and down and back and forth is not how its supposed to be.
Being able to tilt the front end of the shaft a centimeter isnt that bad, its aligned in the pilot bearing inside the flywheel, and the outer hollow shaft sits on this wheel drive shaft with a needle bearing.
Being able to tilt the front end of the shaft a centimeter isnt that bad, its aligned in the pilot bearing inside the flywheel, and the outer hollow shaft sits on this wheel drive shaft with a needle bearing.
Similar threads
