Clutch wont disengage

J

jared_t

New member

Level 1

Joined

Apr 29, 2012

Messages

4

First name

jared

• Apr 29, 2012

• #1

Just got a 6211 tractor, clutch does not disengage properly. If i pump the petal realy fast a lot of times the clutch will start to work kind of, but just a little at the bottom. I replaced the slave cylinder, and bleed the line with no change. Do i need to replace the master cylinder, or is this something worse???

thanks, Jared

 

I

ixer0

Zetor understander

Level 2

Joined

Nov 19, 2006

Messages

865

Location

England, Vereinigtes Königreich

First name

ixer0

• Apr 29, 2012

• #2

Probably the master cyl if you've got no pressure on the pedal.

Mike

 

J

jared_t

New member

Level 1

Joined

Apr 29, 2012

Messages

4

First name

jared

• Apr 29, 2012

• #3

Thanks Mike, I will try this as soon as i get time, and let you know.

 

J

jared_t

New member

Level 1

Joined

Apr 29, 2012

Messages

4

First name

jared

• May 7, 2012

• #4

Master cyinder does not seem bad. before i change that, why does the clutch beed off after i get it pumped up? I do not seem to be losing fluid in the system.???

help Jared

 

Renze

Administrator

Staff member

Joined

Jul 5, 2003

Messages

4,064

Location

Laag Zuthem

First name

Renze

Machinery:

1976 5718
1978 5718 35kmh: Work in progress
1967 3011

• May 7, 2012

• #5

its got air in it.

when the fluid is low, you first get air in the clutch, because it taps into the canister at a higher level: So the clutch will stop before the brakes will run out of fluid.

 

J

jared_t

New member

Level 1

Joined

Apr 29, 2012

Messages

4

First name

jared

• May 20, 2012

• #6

Bleed the clutch, no change, i took off the inspection plate, and i can see the shaft and bearing moving, but nothing else. What is this about? Is there adjustment inside? or does this mean i need a new clutch????

Thanks
Jared

 

Renze

Administrator

Staff member

Joined

Jul 5, 2003

Messages

4,064

Location

Laag Zuthem

First name

Renze

Machinery:

1976 5718
1978 5718 35kmh: Work in progress
1967 3011

• May 20, 2012

• #7

Is it touching the pressure fingers ? it might be just out of adjustment.

 

I

ixer0

Zetor understander

Level 2

Joined

Nov 19, 2006

Messages

865

Location

England, Vereinigtes Königreich

First name

ixer0

• May 20, 2012

• #8

Hi,

Sounds like a broken buttress cap. You should find some posts covering replacement.

Mike