Meshing Gears?

C

Cuz

Guest

• Aug 30, 2006

• #1

Everytime I put my 5211 in neutral and let the clutch out I cant seem to get the gears to mesh back up again without them grinding? I even tried turning the idle down real low but even with the clutch pushed in again, they just dont want to mesh up again.

Any tricks?

Thanks!
Cuz

 

Renze

Administrator

Staff member

Joined

Jul 5, 2003

Messages

4,064

Location

Laag Zuthem

First name

Renze

Machinery:

1976 5718
1978 5718 35kmh: Work in progress
1967 3011

• Aug 30, 2006

• #2

There is a simple transmission shaft brake working on the 4th gearwheel to brake down the lower shaft to make shifting a little easier. I dont know if it is actuated with the brakes or the clutch.
This brake is just a block of metal gently pushing against the gearwheel.

 

C

Cuz

Guest

• Aug 30, 2006

• #3

Maybe I should try stepping on the brake to see if that helps

I have always been on level ground and stopped so I never had the brake applied. I would feel stupid if its that easy of a cure.

Thanks!
I'll give that a try when tilling this weekend.
CUZ

 

C

Cuz

Guest

• Aug 31, 2006

• #4

Just got my owners manual today and it says I should double clutch. I had the same grinding problem when shifitng to a higher gear and again the manual says when do so you should also double clutch.. The only problem with that is by the time I double clutch from a roll, the tractor will already have stopped

 

I

internash

Guest

• Aug 31, 2006

• #5

This has got me wondering... is zetor syncromesh??? i have had problems with a 7011 in the past when changing gear so i just put it in a slow gear and kept it there the whole time. but on my leyland it is syncromesh and it will change to any gear with no grinding

 

D

dieselman

New member

Level 1

Joined

Aug 11, 2005

Messages

3

First name

Dieselman

• Sep 4, 2006

• #6

Hi There

I believe the syncromesh gerbox came first with the 7745, so if you have a older one the gearbox is not syncronized. I believe your clutch is a little too loose (it doesnt decluth enough), try adjusting it to specs and see if there is any change in changing gears. I did this to my 7011 and now it runs like a dream.

Good Luck

Linus in Sweden with four Zetors

 

Renze

Administrator

Staff member

Joined

Jul 5, 2003

Messages

4,064

Location

Laag Zuthem

First name

Renze

Machinery:

1976 5718
1978 5718 35kmh: Work in progress
1967 3011

• Sep 4, 2006

• #7

my brothers 6718 of 1976 has also synchro 4th and 5th speed. it was an option at that time.