• Hello Guest, you do not yet have the necessary rights to see the contents of our FAQ articles. Register in our forum, briefly introduce yourself and your Zetor in words and pictures and actively participate in discussions in the forum, then you will automatically receive access to the specialist articles in the FAQ.

question Zetor 8011 - making a 4wd from?

timos

Member
Level 2
Joined
Jan 13, 2019
Messages
6
Location
Kerkenveld
First name
TimoS
Machinery:
Zetor 8011 1976
Zetor 5341 2001
Zetor forterra 11441 2007
Zetor forterra 120 hsx 2012
Zetor proxima 100 hs 2022
Hey,
I have an 8011 from 1976, but now I think about making four-wheel drive

Is there maybe someone here who has experience with converting 8011 into an 8045?

Regards,
timo
 
I did one before on a 8011 but it was 87 model, but the principles would be the same you need to split the tractor in front of the backend and put in two gears out of a 4wd tractor and then all the parts needed like the front axle housing, the axle, drive shaft, oil pipes, gearbox and the cable. Not an easy job unless you have a scrapped 4wd tractor as a donor to get the parts off as I had.
 


I found a set on a Polish website
Should there only be a gear on the gearbox, another front axle underneath + drive shaft?
Or there is much more to be done about it.

can I possibly work with this?

 

Looks like you get all the parts in the pictures, only that axle is off a 6 cylinder tractor so would need to shorten the driveshaft. There is a gear in the backend but will need to add in 2 more to make your tractor into a 4wd and they need to be the right ratio to suit your front wheels. These are not in any picture.
You will also need an engine mount to suit the axle and that's not in the pictures either.
 

Users who are viewing this thread

Cookies are required to use this site. You must accept them to continue using the site. Learn more...