Search results for query: *

Big Doug; Thx for info. It was in 4WD low range on open field. I tried it in 4WD high range and awhile the field is wet today very little lockup/clunk. I tried it in 2WD and no problem. Why in 4WD low especially. THX Fox

My 1988 7745 clunks/jerks when turning. Other than that it is a good tractor that I use very little, usually just for moving snow in the winter. I believe I read somewhere in this forum that the the gears/brakes load up and it has to be driven reversed to unwind it. Any ideas? Also I...

Thanks. I'll check it out. My tube that the red cap is on can be pulled right out. Perhaps it has broken off. I will try a bit of oil. Thanks David

Not sure if I asked the right question but there is a plate beside the clutch marked clutch release and under it is a tube with a red top on it. Mine is loose but I guess that is where the lube oil goes. I thought I saw something on this site about it but cannot find it. Any suggestions.

How do I lubricate the clutch release bearing on my 7745? Ir seems to stick once in a while. How much lubricant? Thanks David

Clutch now works fine. Thx

Thx....great site ....will give it a try David

I need to top up my brake fluid reservoir which also supplies clutch from center portion of reservoir. What fluid can I use? Thx David

Recently awhile pushing heavy snow my clutch stayed engaged and I cut the fuel to stop. The pedal would not spring back. After I restarted all seemed OK. It was a hard push in 3rd gear for 150 metres and I wonder if I just heated up the clutch momentarily or is there another problem. Thanks

I'm very happy with my 7745. I'm sure they have good points and bad. Any thing to watch out for or avoid. Thx David

Thanks for pointing me toward a possible solution. Fox

My 7745 clutch was recently replaced. It does not engage until all the way out. It does so after a second or so. The Tractor Repair Shop who installed it says this is natural in a hydraulic clutch. In cold weather it takes a few seconds before the tractor moves. Can I adjust it to activate...

Mike: Thx, I'll check it out. It has no down pressure, only lift and cannot lift too much either. Thx Foxman

Anyone know lift capacity of 3 pt hitch on front of 7745? Thx Foxman

When I lift my front 3 pt hitch it is hard to control and jerks. Seems like it gets all the oil at once. Any ideas?

WOW! Seems like a lot of sludge. I found a few specks of metal too. Pulled them out with a magnet. Maybe filings from manufacture? Maybe something else. Time will tell. Thx Foxman

Thx for info. I changed oil and oil filter/spinner canister. It had a good 1/16" of black crud/dirt that I scraped off. Would this be normal accumulation after 200 hrs or so. seems excessive to me. I've never cut open a paper filter but was wondering how much dirt and crud gets in them...

Anyone know where I can get 7745 Workshop or Repair Manuals. I live in northern Ontario, Canada. Thanks Foxman

This is a 7745 FWD We've changed fluids and put her to work. Lots of power, no smoke and good temps. Only problem is right brake has little stopping power but left seems OK. I need to buy a repair/shop manual. Anyone know where to get one? Foxman

Guys; Thx for the responses and I will try to free up the low range by reversing. The muffler looks new but is cracked at the bottom just above the manifold. I could weld it but is an after market muffler a better way to go or is Zetor original a special muffler?. I live in northern Ont...