4341 brake problem

[bill wilson]

hy fellows, my problem is the brakes on a 4341,i can pump them three times and i have brake peddle,but the brakes are still not good. could one of the master cylenders cause this.i see that both cylenders plumbed together. any help ,thanks

 

[Renze]

Did you top up the brake oil ?? and if so, how soon will the brake oil level drop ?

Is the clutch still functioning ? the hydraulic clutch uses the same type of master cylinder and the same brake fluid reservoir

 

[bill wilson]

renze,thanks for your reply.anwser to your 1st quston,i have toped off my oil reservor,and it dosnt seem to be losing any fluid.also my emergency brake dosnt work.the clutch is working fine.I first noticed the brakes getting soft and then they quit completly. after pumping them three time the brake peddle is hard but the brakes are less than half .compaired to beforany more info will be a big help . thanks again

 

[bill wilson]

Did you top up the brake oil ?? and if so, how soon will the brake oil level drop ?

Is the clutch still functioning ? the hydraulic clutch uses the same type of master cylinder and the same brake fluid reservoir

 

[Renze]

maybe you have air in the system. Did you bleed it at the bleed screw at the slave cylinders ?
On a disk brake tractor, it shoudl be easy to find. One person has to pump the pedal and the other has to open and close the bleed valve