6045 slasher set up

[schuette]

What size slasher/bush hog can a 6045 PTO drive?
Is 6ft slasher too big?
What PTO setting should be selected? 540 or 1000?
Once hooked up, which levers control the 3 point hitch?
Do I switch the inner circuit off by sliding the lever forward and sliding the outer aft?
The hydraulic lever for the rear will lift the slasher deck up no doubt.

Appreciate the assistance. Tis

 

[diyfarmer]

What size slasher/bush hog can a 6045 PTO drive?
Is 6ft slasher too big?
What PTO setting should be selected? 540 or 1000?
Once hooked up, which levers control the 3 point hitch?
Do I switch the inner circuit off by sliding the lever forward and sliding the outer aft?
The hydraulic lever for the rear will lift the slasher deck up no doubt.

I think you will have excuse me but you will have to translate this, (as we obviously are from different parts of the world) I take it that a slasher/ bush hog is some type of mower or scrub topper, if so a 6ft mower would be prefect for 6045 and run it at 540.
You need to use the handle closes to the mudguard for the lift, and put the hyd handle in the middle of the slide which is neutral.
If you move all back or all the forward it will be engaging the hydraulic pump and you would hear engine humming under pressure.