Trans stuck in gear with a cab

[txronm]

Wonderfull to find this site!!

I have a 7711 stuck in reverse (which bothers me this tractor has less than 1500 hours on it).

I have already read several posts that describe how to align everything, my problem is that I have a cab!!!

I am going to go and take a look and see if there is any way to remove the center of the cab floor, otherwise I may have to make an access door.

A couple of posts talk about removing a bolt and using a screwdriver? I can't see the top of the housing, so I can't visualize what they mean.

Any suggestions or comments?

Thanks!!

 

[ixer0]

Hi,

If you remove the 3 small panels below the dash which are around the steering column and the floor mats you'll find the bolts to remove the centre floor section.

Mike

 

[txronm]

Thanks!

I got it back in place last night, it's raining today so I will have to get the cab floor back together later.

The posts were correct, and hour to uncover it and 5 minutes to fix it.

I will be visiting the forum regularly.

Ron