• Hello Guest, you do not yet have the necessary rights to see the contents of our FAQ articles. Register in our forum, briefly introduce yourself and your Zetor in words and pictures and actively participate in discussions in the forum, then you will automatically receive access to the specialist articles in the FAQ.

cab heat

roadking

New member
Level 1
Joined
Dec 2, 2013
Messages
2
First name
Steve Kmyta
I have a 5245 zetor with no cab ,I bought a used cab and installed it on my tractor.....big job!

My question is where do I connect my cab heater hoses for best results????
 
I have a 5245 zetor with no cab ,I bought a used cab and installed it on my tractor.....big job!

My question is where do I connect my cab heater hoses for best results????

One goes on the back of watermanifold. you might have to buy an original outlet that screws into the manifold. the other one goes on a fipe that comes from the waterpump if i remember correctly. you might have to buy the pipe accessories too.

 
Yes, the feed hose is screwed directly into the water pump. Its plugged with an inner hex head screw on cabless tractors.
 
thanks gentlemen,

found both plugs .... the water manifold I figured was 1 but I wasn't sure of the water pump fitting after giving the front of the engine a good bath there it was!

thanks again for your help

Regards

Steve
 

Users who are viewing this thread

Cookies are required to use this site. You must accept them to continue using the site. Learn more...