ZETOR 7245

[gsp974]

I JUST BOUGHT AN OLD AETOR 7245 4X4 TRACTOR.. I LOVE IT BUT I HAVE SOME SIMPLE QUESTIONS... I CANNOT GET IT INTO GEAR WITHOUT GRINDING THE GEARS... I PUT A NEW SLAVE CYLINDER AND BLEED IT..I CLEANED IT UP AND NEED NOW THE 4X4 WONT ENGAGE... THE SHAFT SLID OUT OF THE TRANNY ANS I PUT NEW O-rings IN IT. NOW IT JUST GOES AROUND AND AROUND.. 4 WHEEL DRIVE WILL NOT ENGAGE.. DOES ANTONE HAVE A OWNERS MANUAL AND A PARTS MANUAL I CAN DOWNLOAD...I AM HAVEING A BALL... THIS IS A BEAST OF A TRACTOR WHEN ALL IS DONE I AM PUTTING FRONT END LOADER ON HER TOO... HER NAME IS BULLDAWG...LOOKFORWARD TO HEARING FROM YALL!!!!

 

[ixer0]

Hi,

If you still have clutch problems after you've fitted the cylinder it has probably broken a buttress cap. This is accessible through the inspection plate on the side of the bell housing. It's the cap the release levers pivot on. There are 3 of them.
The 4wd shaft is keyed onto the fork, so they have dropped out when you pulled it out. You'll have to remove the drop box to fix it.
Have fun.

Mike