My 7245 has real slow hydralics and the front end loader is doing good to lift 100lbs.
So far I replaced the filter ,new fluid,pulled /cleaned the screen ,replaced the pump ,replaced the safety/popoff valve .
I have tryed every combo of inner /outer circut but still slow.
I looked in the manusl and it says that in the 540 PTO the flow is 8.4 gpm and at 1000 PTO it is 13.4 gpm.In the manual it shows that to the left on the PTO shat drive lever it is 540 ,center is N and right is 1000.
On mine left is the 540 and to the right is N but it does not go any further right then N.
So I read in the manual on how to change the 6 spline 540 shat out and install the 21 sline 1000 shaft ,if I take the 1000 shaft out from under the shift lever and install it at the rear of the tractor [PTO output] and then put the 540 under the shaft drive lever slot, will this speed the PTO/pump up to the 1000 RPM giving me 13.4 GPM at the pump.Will this help with my slow week hydralics?
THANKS
So far I replaced the filter ,new fluid,pulled /cleaned the screen ,replaced the pump ,replaced the safety/popoff valve .
I have tryed every combo of inner /outer circut but still slow.
I looked in the manusl and it says that in the 540 PTO the flow is 8.4 gpm and at 1000 PTO it is 13.4 gpm.In the manual it shows that to the left on the PTO shat drive lever it is 540 ,center is N and right is 1000.
On mine left is the 540 and to the right is N but it does not go any further right then N.
So I read in the manual on how to change the 6 spline 540 shat out and install the 21 sline 1000 shaft ,if I take the 1000 shaft out from under the shift lever and install it at the rear of the tractor [PTO output] and then put the 540 under the shaft drive lever slot, will this speed the PTO/pump up to the 1000 RPM giving me 13.4 GPM at the pump.Will this help with my slow week hydralics?
THANKS