Thanks for letting me in the forum. Been reading through and it's pretty fun and informative.
My problem is that my 3-point lift won't lift. I check the trans-hid level and it's fine. It was working yesterday so I'm hoping that maybe there is a button or lever that I might have turned off by mistake or that I can't find. (I'm pretty new to this machine.)
When I first had the problem this morning my first reaction was to top up the trans-hyd fluid. So that's OK. Steering seems just fine. If the levels were too low, is it possible that there is air in the cylinder that lifts the 3ph? If so, do I bleed just that cylinder?
Thanks for any input.
J
My problem is that my 3-point lift won't lift. I check the trans-hid level and it's fine. It was working yesterday so I'm hoping that maybe there is a button or lever that I might have turned off by mistake or that I can't find. (I'm pretty new to this machine.)
When I first had the problem this morning my first reaction was to top up the trans-hyd fluid. So that's OK. Steering seems just fine. If the levels were too low, is it possible that there is air in the cylinder that lifts the 3ph? If so, do I bleed just that cylinder?
Thanks for any input.
J