Search results for query: *

The later type seal is more robust and is not affected in the same way as the earlier type either by blow down or slight shaft movement.

Thanks for the info I suppose that the real problem is the blow down on the engine and not the seal and a recent refurb of the head has only compounded the problem, so extra venting may help in the short term but it seems that the cure will be pistons and liners ect.

Hi was the head pressure tested when it was off as I have seen a similar problem and the head was the problem. L

Hi, the back engine seal on my 8011 is leaking engine oil, we dismantled the tractor only to find that it is fitted with the early type seal which consists of a steel ring /oring and splash plate, everything looked ok but we fitted a new steel ring/ oring anyway,on reassembly the problem is...

Hi all, We are currently rebuilding the bottom end of an 8011 and need to get replacement parts which include piston / liners, oil pump, crankshaft bearings and plugs,seals and gaskets. Any idea who the best value for these parts ? Regards L.

----Hi I got the old unit in an 8011 converted to hydro static by getting the following done, remove the unit from the tractor, remove the cone assembly where the steering rod goes in ,fit a plate the same as the plate on the front of the unit. Fit a suitable danfoss unit.Oil supply and return...

Hi I recently bought an 8011 crystal which is blowing white smoke from the exhaust when running, not a lot but enough to be noticable. The frost plugs are popped and i had it running with a water hose filling into the rad so its not possible to check for bubbles in the rad, also no water in the...

Hi usually when the brakes stick on especially when they have been working ok is that the master cylinder has not released the brake fluid from the slave cylinder,if this is the case you can quickly free the brake by releasing the brake fluid from the slave cylinder by opening the bleed screw on...

Good stuff can I fit a 14145 turbo or do I go with a smaller model, maybe one from a 4 cyl tractor, other concerns are the crankshaft and conrods up to the extra power...........Liam.

Hi we currently are rebuilding the engine on an 12045 and as turbo pistons are being fitted I am wondeing can we instal a turbo to the engine, if we can what type or size should we look for? regards Liam.

Thanks for the information but I am more concerned with setting up the injector pump timing correctly. My understanding of this procedure is to locate top dead center on number one piston and having the pump fully primed move it on the slots to obtain fuel movement in number one port of the inj...

Hi recently having fitted a recon inj pump to my 12045 i now need to spill time this .How do I do this ? Also i need to check the valve clearance and need the inlet / exhaust settings and a simple way of doing this. Liam.